Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 209)

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 6-11
Configuration - T1 Controller Mode
shutdown
Use the Controller T1 shutdown command to set the T1 interface down (out-of-service). To set the T1
up (in-service) see no shutdown command on page 6-10.
Syntax:
(config-cont-t1-{ n})# shutdown
Example:
(config-cont-t1-1)# shutdown
Supported Platforms: Adit 3104, Adit 3200, Adit 3500
tdm-group
Use the Controller T1 tdm-group command to create a group and define its direction. To delete a TDM
group, see no tdm-group command on page 6-10.
Syntax:
(config-cont-t1-{ n})# tdm-group timeslots range dir
{in|in-out|out}
Example:
(config-cont-t1-1)# tdm-group timeslots 1-4 dir in-out
Supported Platforms: Adit 3104, Adit 3200, Adit 3500
Field Definition
range TDM timeslot range, in the format n-n (1-4). Range is 1 - 24.
in Defines the direction as incoming only.
in-out Defines the direction as both incoming and outgoing.
out Defines the direction as outgoing only.