Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 199)

C
HAPTER
6
Configuration - T1 Controller Mode
The T1 Controller Configuration commands allow the user to configure the T1 parameters on the Adit
3000 series.
Note: The T1 Controller Configuration mode is supported by the Adit 3000 series only. For Controller
Configuration commands for the MSR card, see Chapter 5, Configuration - LCC Controller Mode.
This sub-group is entered with the (config)# controller t1 command from the Configuration mode.
The T1 Controller commands are represented by the (config-cont-t1-{n})# prompt.
T1 Controller Commands
• description • lbo
• do • linecode
• ds0-group • loopback
• end • loopdetect
• exit • no commands
• fdl • pri-group
• framing • shutdown
• history • tdm-group
• idle-pattern • threshold