Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 50)

2-26 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
User Mode
show port-trigger
Use the show port-trigger command to display all port triggering information.
Syntax:
> show port-trigger
Example:
Adit 3500> show port-trigger
Service ID:134217730 Enable Service Name:L2TP
Trigger protocol: UDP port: src_start=0 src_end=0 dst_start=1701 dst_end=1701
Service ID:16777223 Enable Service Name:TFTP
Trigger protocol: UDP port: src_start=1024 src_end=65535 dst_start=69 dst_end=69
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
show route
Use the show route command to display the routing table.
Syntax:
> show route
Example:
Adit 3500> show route
Destination Gateway Flags Metric Interface
192.168.1.0/24 * U 50 Ethernet 1
192.168.1.0/24 * U 51 IPsec 1
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR