Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 372)

16-6 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - OSPF Mode
network area
Use the Router OSPF network area command to define the interfaces on which OSPF will run and set
the ID for those interfaces. To disable OSPF routing for the interface defined, see no network area
command on page 16-8.
Syntax:
(config-ospf)# network address wildcard-mask area area-id
Example:
(config-ospf)# network 192.168.1.1 0.0.0.255 area 1
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
address IP address
wildcard-mask IP address-type mask that includes "don’t care" bits.
area-id Identifier of the stub area, in the form:
ID number - Range 0-4294967295
IP address - IP address of the area.
If you intend to associate areas with IP subnets, specify a subnet
address as the value of the area-id.