13–configuration - serial interface mode, Configuration - serial interface mode, Chapter 13, configuration - serial interface mode – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 297: Hapter, Serial interface commands
Advertising
C
HAPTER
13
Configuration - Serial Interface Mode
The Serial Interface Configuration commands allow the user to configure the serial interface
parameters.
Enter this sub-group with the (config)# interface serial number command from the Configuration
mode.
The Serial Interface commands are represented by the (config-int-ser-{n})# prompt.
Note: Before configuring serial interface parameters, you must enable PPP encapsulation on the
interface using the encapsulation ppp command.
Serial Interface Commands
• do
• end
• exit
• firewall
• history
• ip rip
• ip route
• ip mtu
• metric
• shutdown
• sip-alg
Advertising