No ip ospf message-digest-key, No ip ospf priority, No ip ospf retransmit-interval – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 358
15-16
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - L2TPC Mode
no ip ospf message-digest-key
Use the L2TPC no ip ospf message-digest-key command to remove an old MD5 key. To enable
OSPF MD5 (Message-Digest) authentication, see ip ospf message-digest-key command on
page 15-8.
Syntax:
(config-l2tpc-{n})# no ip ospf message-digest-key
key-id
Example:
(config-l2tpc-1)# no ip ospf message-digest-key 1
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf priority
Use the L2TPC no ip ospf priority command to set the router priority to the default setting of
priority 1. To set the router priority, which determines the designated router for this network, see ip
ospf priority command on page 15-9.
Syntax:
(config-l2tpc-{n})# no ip ospf priority
Example:
(config-l2tpc-1)# no ip ospf priority
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf retransmit-interval
Use the L2TPC ip ospf retransmit-interval command to restore the default value of 5 seconds. To
define the interval of time between link state advertisement retransmissions for adjacencies
belonging to the interface, see ip ospf retransmit-interval command on page 15-9.
Syntax:
(config-l2tpc-{n})# no ip ospf retransmit-interval
Example:
(config-l2tpc-1)# no ip ospf retransmit-interval
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field
Definition
key-id
Enter an ID for this key. Range is 1-255.