Ip address, Ip default-route, Ip mtu – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 302: Ip address -6 ip default-route -6 ip mtu -6
13-6
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Serial Interface Mode
ip address
Use the Serial Interface ip address command to configure the IP address for the serial interface. To
remove an IP address, see no ip address command on page 13-15.
Syntax:
(config-int-ser-{
n})# ip address {address mask mask|auto
|unnumbered} [secondary]
Example:
(config-int-ser-1)# ip address 192.168.2.100 mask 255.255.255.0
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
ip default-route
Use the Serial Interface ip default-route command to enable the default route. To disable the default
route, see no ip default-route command on page 13-15.
Syntax:
(config-int-ser-{
n})# ip default-route enable
Example:
(config-int-ser-1)# ip default-route enable
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
ip mtu
Use the Serial Interface ip mtu command to set the Maximum Transmission Unit. Sets the largest
packet size (bytes) the network will allow to transmit.
Syntax:
(config-int-ser-{
n})# ip mtu {size|auto}
Example:
(config-int-ser-1)# ip mtu auto
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field
Definition
address
Enter an IP address to assign to the port.
mask
Enter a subnet mask for the IP address.
auto
Uses IPCP to assign an IP address.
unnumbered
Treat this as an un-numbered interface, as per RFC 1812.
secondary
Optional parameter, defines the address to be a secondary IP address.
Field
Definition
size
Allows the user to set the Maximum Transmission Unit (MTU).
size = range of 576 to 1500 bytes.
auto
Auto sets the MTU at 1500 bytes.