Modem-protocol, Modem-protocol -7 – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 225
Advertising
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
8-7
Configuration - Dial Peer FXS Mode
modem-protocol
Use the Dial Peer modem-protocol command to configure the modem protocol.
Syntax:
(config-dpeer-fxs)# modem-protocol {none|pass-through}
Example:
(config-dpeer-fxs)# modem-protocol pass-though
Supported Platforms:
Adit 3104, Adit 3500, MSR
Field
Definition
none
A Modem call would be treated as a normal voice call. Default.
pass-through
Will cause the line to transmit in G.711 mode, with echo cancellation
and silence suppression disabled, on detection of Modem tone.
Advertising