No ip ospf retransmit-interval, No ip ospf transmit-delay, No ip primary-dns – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 394: No ip rip
17-16
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - PPTPC Mode
no ip ospf retransmit-interval
Use the PPTP Client ip ospf retransmit-interval command to restore the default value of 5
seconds. To define the interval of time between link state advertisement retransmissions for
adjacencies belonging to the interface, see ip ospf retransmit-interval command on page 17-9.
Syntax:
(config-pptpc-{n})# no ip ospf retransmit-interval
Example:
(config-pptpc-1)# no ip ospf retransmit-interval
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf transmit-delay
Use the PPTP Client no ip ospf transmit-delay command to restore the default value of 1 second.
To define the estimated time to transmit a link state update packet on the interface, see ip ospf
transmit-delay command on page 17-9.
Syntax:
(config-pptpc-{n})# no ip ospf transmit-delay
Example:
(config-pptpc-1)# no ip ospf transmit-delay
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip primary-dns
Use the PPTP Client no primary-dns command to disable the primary DNS. To set the DNS
primary IP address, see ip primary-dns command on page 17-10.
Syntax:
(config-pptpc-{n})# no ip primary-dns
Example:
(config-pptpc-1)# no ip primary-dns
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ip rip
Use the PPTP Client no ip rip command to disable RIP on this interface.
To enable RIP, see ip rip
Syntax:
(config-pptpc-{n})# no ip rip
Example:
(config-pptpc-1)# no ip rip
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR