Ip route-mode, Ip secondary-dns, Metric – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 390: Ip route-mode -12 ip secondary-dns -12 metric -12
17-12
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - PPTPC Mode
ip route-mode
Use the PPTP Client ip route-mode command to configure the routing mode.
Syntax:
(config-pptpc-{n})# ip route-mode {napt|route}
Example:
(config-pptpc-1)# ip route-mode napt
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
ip secondary-dns
Use the PPTP Client ip secondary-dns command to configure the secondary DNS. To delete a
secondary DNS address, see no ip secondary-dns command on page 17-17.
Syntax:
(config-pptpc-{n})# ip secondary-dns
address
Example:
(config-pptpc-1)# ip secondary-dns 192.168.1.200
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
metric
Use the PPTP Client metric command to configure the
Metric of the IP network on this interface
.
Syntax:
(config-pptpc-{n})# metric
metric
Example:
(config-pptpc-1)# metric 150
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field
Definition
napt
Set to NAPT mode. Default.
NAPT is used if doing private IPs on the Ethernet side or if you want
to hide specific publics on the internal side.
route
Set to Route mode. Routing is used if public is visible on both sides.
Field
Definition
address
Enter the IP address of the secondary Domain Name Server (DNS).
Field
Definition
metric
Range is 0-255, with a default is 10.