Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 311)

Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI 13-15
Configuration - Serial Interface Mode
no ip address
Use the Serial Interface no ip address command to remove the IP address assigned to the serial
interface. To set the Serial IP address, see ip address command on page 13-6.
Syntax:
(config-int-ser-{ n})# no ip address address
Example:
(config-int-ser-1)# no ip address 192.168.1.100
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ip default-route
Use the Serial Interface no ip default-route command to disable the default route. To set the default
IP address, see ip default-route command on page 13-6.
Syntax:
(config-int-ser-{ n})# no ip default-route
Example:
(config-int-ser-1)# no ip default-route
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf authentication
Use the Serial Interface no ip ospf authentication command to disable the authentication method
for this serial interface. To enable the authentication type for this interface see ip ospf authentication
command on page 13-7.
Syntax:
(config-int-ser-{ n})# no ip ospf authentication
Example:
(config-int-ser-{ n})# no ip ospf authentication
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf authentication-key
Use the Serial Interface no ip ospf authentication-key command to remove a password to be used
by neighboring routers, that are using OSPF’s simple password authentication. To assign a
password, see ip ospf authentication-key command on page 13-8.
Syntax:
(config-int-ser-{ n})# no ip ospf authentication
Example:
(config-int-ser-1)# no ip ospf authentication-key
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
address Enter the IP address to remove.