No commands, No idle-time, No ppp authentication – Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none User Manual
Page 407: No ppp encryption, No commands -5
Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
18-5
Configuration - PPTPS Mode
no commands
no idle-time
Use the PPTP Server no idle-time command to reset the idle time to the default setting. To set the
maximum idle time for a PPTP connection, see idle-time command on page 18-4.
Syntax:
(config-pptps)# no idle-time
Example:
(config-pptps)# no idle-time
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ppp authentication
Use the PPTP Server no ppp authentication command to disable PPP authentication. To enable
PPP authentication, see ppp authentication command on page 18-6.
Syntax:
(config-pptps)# no ppp authentication {chap|ms-chap|
ms-chapv2|pap}
Example:
(config-pptps)# no ppp authentication
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
no ppp encryption
Use the PPTP Server no ppp encryption command to disable PPP encryption. To enable PPP
encryption, see ppp encryption command on page 18-6.
Syntax:
(config-pptps)# no ppp encryption {40-bit|128-bit|stateful}
Example:
(config-pptps)# no ppp encryption
Supported Platforms:
Adit 3104, Adit 3200, Adit 3500, MSR
Field
Definition
chap
Support Challenge Handshake Authentication (CHAP)
ms-chap
Support Microsoft CHAP (MS-CHAP).
ms-chapv2
Support Microsoft CHAP Version 2 (MS-CHAPv2).
pap
Support an unencrypted password. Default.
Field
Definition
40-bit
MPPE-40 - Microsoft PPP encryption algorithm.
128-bit
MPPE-128 - Microsoft PPP encryption algorithm.
stateful
Enable the stateful state for encryption.