Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 312)

13-16 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Serial Interface Mode
no ip ospf cost
Use the Serial Interface no ip ospf cost command to reset the cost path to the default setting of 0.
To define the cost of sending a packet on this serial interface, see ip ospf cost command on
page 13-8.
Syntax:
(config-int-ser-{ n})# no ip ospf cost
Example:
(config-int-ser-1)# no ip ospf cost
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf dead-interval
Use the Serial Interface no ip ospf dead-interval command to reset the interval of time to the
default setting of 40 seconds. To define the interval of time that no hello packets have been seen
before neighbors declare the router down, see ip ospf dead-interval command on page 13-8.
Syntax:
(config-int-ser-{ n})# no ip ospf dead-interval
Example:
(config-int-ser-1)# no ip ospf dead-interval
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf disable
Use the Serial Interface no ip ospf disable command to enable OSPF processing on this interface.
To disable OSPF on this interface, see ip ospf disable command on page 13-9.
Syntax:
(config-int-ser-{ n})# ip ospf disable all
Example:
(config-int-ser-1)# ip ospf disable all
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf hello-interval
Use the Serial Interface no ip ospf hello-interval command to reset the interval of time to the
default setting of the path cost to the default setting of 10 seconds. To define the interval of time
between hello packets that are sent on the interface, see ip ospf hello-interval command on
page 13-9.
Syntax:
(config-int-ser-{ n})# no ip ospf hello-interval
Example:
(config-int-ser-1)# no ip ospf hello-interval
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR