Carrier Access Adit 3000 Series and Multi-Service Router (MSR) Card none - Manual (Page 284)

12-14 Adit 3000 (Rel. 1.6) and MSR Card (Rel 2.0) CLI
Configuration - Multilink Interface Mode
no commands
no firewall
Use the Multilink Interface no firewall command to disable the configured firewall. To enable the
firewall on this interface, see firewall command on page 12-4.
Syntax:
(config-int-mlink-{ n})# no firewall
Example:
(config-int-mlink-1)# no firewall
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ip address
Use the Multilink Interface no ip address command to remove the IP address assigned to the port.
To set the Ethernet IP address, see ip address command on page 12-5
Syntax:
(config-int-mlink-{ n})# no ip address address
Example:
(config-int-mlink-1)# no ip address 192.168.1.100
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ip default-route
Use the Multilink Interface no ip default-route command to disable the default route. To set the
default IP address, see ip default-route command on page 12-6.
Syntax:
(config-int-mlink-{ n})# no ip default-route
Example:
(config-int-mlink-1)# no ip default-route
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
no ip ospf authentication
Use the Multilink Interface no ip ospf authentication command to disable the authentication
method for this Multilink interface. To enable the authentication type for this interface see ip ospf
authentication command on page 12-7.
Syntax:
(config-int-mlink-{ n})# no ip ospf authentication
Example:
(config-int-mlink-{ n})# no ip ospf authentication
Supported Platforms: Adit 3104, Adit 3200, Adit 3500, MSR
Field Definition
address Enter the IP address to remove.