Rockwell Automation 2755-SNx Adaptascan Bar Code Readers - Manual (Page 118)

7–12 Communicating with an SLC on a DH-485 Network
Publication 2755-6.8
Configure the Decoder Trigger
This application uses a Timer to trigger the reader’s decoder. The
Timer is typically used during application setup. Refer to Publication
No. 2755-837 for other input sources that trigger the decoder.
1. Click the Decoder button from the main Project dialog.
2. Under Triggered By, select Timer from the Input list.
3. Click the Save button.
4. Click the Close button and return to the main Project dialog.
Configure the Serial Port
1. Click the Serial Port button from the Project dialog.
2. Configure the serial port as follows:
•
From the Protocol list box, select DH-485
•
From the Baud Rate list box, select 19,200
•
From the Connection list box, select RS485
The configuration must match the host configuration.