Rockwell Automation 2755-SNx Adaptascan Bar Code Readers - Manual (Page 15)

Preface P–2
Publication 2755-6.8
The following table describes the contents of this manual.
Chapter Title Contents
Preface
Describes the purpose, background, and scope of
this guide. Also specifies the audience for whom
this guide is intended.
1
Using the Auto-Load
Function Describes how to configure the reader to autoload
data into the match code table.
2
Using ASCII Command
Input
Shows how to configure the reader to start/stop
scanning when receiving ASCII commands from a
terminal emulator and then display the bar code
data on the emulator.
3
Downloading Match
Codes from a Host Device
Shows how to download match codes (and other
host commands) from a terminal emulator to the
reader.
4
Downloading Match
Codes via DH485
Protocol with an
SLC 5/03
t
or
SLC 5/04
t
Controller
Shows how to download match codes from an
SLC 5/03 or SLC 5/04 controller to the reader.
5
Communicating with a
1746-BAS BASIC Module Describes how to configure the reader to
communicate with a 1746-BAS BASIC module.
6
Communicating with an
SLC
t
over an RS-232
Link
Describes how to configure the reader to
communicate with an SLC controller over an
RS-232 serial connection.
7
Communicating with an
SLC on a DH-485
Network Tells how to configure two readers to communicate
with an SLC controller over a DH-485 network
using master mode.
8
Communicating with an
PLC-5
R
over an RS-232
or RS-422 Link
Describes how to configure the reader to
communicate with an PLC controller using either
RS-232 or RS-422 communication.
9
Communicating with an
SLC 5/03 Processor on a
DeviceNet
t
Network
Shows how to configure a reader to communicate
with an SLC controller over a DeviceNet network in
master/slave mode.
10
Communicating with an
SLC 5/03 Processor on a
DeviceNet Network using
Explicit Messaging
Shows how to configure a reader to communicate
with an SLC controller over a DeviceNet network in
master/slave mode using explicit messaging.
11
Communicating with a
PLC-5 Processor on a
DeviceNet Network Shows how to configure a reader to communicate
with a PLC-5 controller over a DeviceNet network in
master/slave mode.
Table continued on the next page.
Contents of this Guide