Rockwell Automation 2755-SNx Adaptascan Bar Code Readers - Manual (Page 278)

14–8 Communicating with a 2760-RB Module on a DH-485 Network
Publication 2755-6.8
This section shows how to configure the AdaptaScan Bar Code
Reader (with v7.1 firmware or later) using the AdaptaScan Software
(Catalog No. 2755-ASN).
The procedures in this section show how to:
•
define the DeviceNet node address of the AdaptaScan Reader
•
configure a bar code label and symbol
•
configure the scanner
•
configure the decoder trigger
•
configure the serial port
•
configure the format of messages and the message destination
The steps may vary for some procedures because of the different
requirements of applications. For example, the bar code labels may
vary from one application to the next.
Create a New Project
Create a new project named RB_DH485 for the AdaptaScan Bar
Code Readers.
1. Choose New from the Project menu to create a new project.
2. Click the New button to add a bar code reader to the project.
Configuring the Bar Code
Reader