Rockwell Automation 2755-SNx Adaptascan Bar Code Readers - Manual (Page 93)

5–11 Communicating with a 1746-BAS BASIC Module
Publication 2755-6.8
2. Configure the serial port as follows:
•
From the Protocol list box, select Terminal
•
From the Connection list box, select RS232
The configuration must match the host configuration.
3. Click Save and then Close to return to the main Project dialog.
Create a Message
Data sent from the AdaptaScan Reader to the BASIC module uses
messages.
1. Click the Message button from the main Project dialog.
2. Under Triggered By, check the Enable check box.
3. Under Device, select Bar Code Reader 1.
4. Under Input, select [Decoder].
5. Click the New button to create a message field.
6. Under Symbol Source, select Bar Code Reader 1.
7. Under Bar Code Labels & Symbols, select Symbol 1.