Rockwell Automation 2755-SNx Adaptascan Bar Code Readers - Manual (Page 213)

11–13 Communicating with a PLC-5 Processor on a DeviceNet Network
Publication 2755-6.8
4. Click Save to save the project under the new name and then Close
to return to the Project dialog.
Change the Baud Rate
If you need to change the baud rate:
1. Click on the K Baud button and select the desired baud rate.
2. Click Save and Close to return to the Project dialog.
3. Click the Device button.
4. Click Apply if the desired baud rate is shown.
5. Click Save and Close to return to the Project dialog.
6. Click the Send Device button.