Rockwell Automation 2755-SNx Adaptascan Bar Code Readers - Manual (Page 122)

7–16 Communicating with an SLC on a DH-485 Network
Publication 2755-6.8
From the main Project dialog, click the Send Device button to send
the configuration to Bar Code Reader 1.
Use the Monitor dialog to verify the decoding of bar code labels.
This section shows how to configure Bar Code Reader 2 which is
node 3 on the DH-485 network.
Add a Second Bar Code Reader to the Project
From the Project dialog, click the New button to add Bar Code
Reader 2 to the project.
Define the DeviceNet Address
1. Click the Device button on the Project dialog.
2. Set the DeviceNet address to 2 for the configuration download.
Note: The DeviceNet address is not always the same as the
DH-485 node address. A DH-485 node address is assigned later.
3. Connect the 2755-NC43 or -NC48 Configuration Cable.
4. Click the Apply button.
5. Click the Close button and return to the Project dialog.
Sending the Configuration
to Reader 1
Configuring Bar Code
Reader 2