Rockwell Automation 2755-SNx Adaptascan Bar Code Readers - Manual (Page 33)

2–6 Using ASCII Command Input
Publication 2755-6.8
Configure the Decoder Trigger
This section defines ASCII Command Input 1 as the trigger for the
reader’s decoder.
1. Click the Decoder button from the main Project dialog.
2. Under Triggered By, select ASCII Command Input 1 from the
Input list.
3. Click the Save button.
4. Click the Close button and return to the main Project dialog.
Configure the ASCII Commands
The following procedure defines the ASCII commands that will
trigger the decoder to start/stop scanning.
1. Click the Input/Output button on the main Project dialog.
2. Under Inputs & Outputs, select ASCII Command Input 1.