Fluke Biomedical Cufflink - Manual (Page 101)

Remote Operation
Command Descriptions
3
3-27
MANOMETER
Use this command to put the Analyzer into the manometer mode. The keys on the
Analyzer front panel become active during this test so a user can zero pressure, do a reset,
or print test results. Press F1 to start measurements. See also: Pop Off Test. There are no
parameters for this command.
Example
Put CuffLink into the manometer mode.
Command manometer
Results The Analyzer enters the manometer test mode and
shows the Manometer display. Press Fl on the
Analyzer keyboard to begin.
fcv056.eps
Returned Data *
MKARM10
Use this command to set blood pressure simulation to Adams Adult 60/30, with a heart
rate of 40 BPM. There are no parameters for this command.
Example
Simulate a specific adult BP of 60/30 at 40 BPM.
Command Mkarm10
Results The Analyzer runs the Adams Adult 60/30, heart rate is set to 40
BPM.
Returned Data *
MKARM20
Use this command to set blood pressure simulation to Adams Adult 80/50, with a heart
rate of 60 BPM. There are no parameters for this command.
Example
Simulate a specific adult BP of 80/50 at 60 BPM.
Command Mkarm20
Results The Analyzer runs the Adams Adult 80/50, heart rate is set to 60
BPM.
Returned Data *