Fluke Biomedical Cufflink - Manual (Page 81)

Remote Operation
Command Descriptions
3
3-7
Command Descriptions
This alphabetized section contains detailed descriptions of the Analyzer's remote
commands. Examples for each command show exactly how to type the command, the
results, and the data returned to the controller, as it appears on the controller's display.
Commands in the Examples sections were written in command syntax for computers. For
information on medTester syntax, refer to Command Syntax for medTester.
Note
Different results from those shown in the examples may be obtained. Except for asterisks,
the Returned Data listed in the following examples is varied, depending on the Analyzer
and the parameter values assigned to the command.
BEEP
Use this command to test Cufflink's speaker and modify the frequency (pitch) and period
(length of the beep). Because the speaker is more difficult to hear at very low and very
high frequencies, be sure the Beeper Volume control on the front panel is set high
enough. Parameters for this command are described below.
Parameter Definition Range Default
FREQ Frequency (Hertz) 76 to 10,000 Hz 440 Hz
PERIOD Period (milliseconds) 50 to 32,000 ms 500 ms
Example
Beep the speaker using Cufflink's default values.
Command beep
Results A 440 Hz tone sounds for 500 milliseconds.
Returned Data *
Example
Beep the speaker at a frequency of 300 Hz for 800 milliseconds.
Command beep freq=300,period=800
Results A 440 Hz tone sounds for 500 milliseconds.
Returned Data *