Fluke Biomedical Cufflink User Manual
Page 4
Repair and calibration:
To find the nearest service center, go to
www.flukebiomedical.com/service
, or
In the U.S.A.:
Cleveland Calibration Lab
Tel:
1-800-850-4606
Email:
Everett Calibration Lab
Tel:
1-888-993-5853
Email:
In Europe, Middle East, and Africa:
Eindhoven Calibration Lab
Tel:
+31-402-675300
Email:
In Asia:
Everett Calibration Lab
Tel:
+425-446-6945
Email:
Certification
This instrument was thoroughly tested and inspected. It was found to meet Fluke Biomedical’s manufacturing specifications when it
was shipped from the factory. Calibration measurements are traceable to the National Institute of Standards and Technology (NIST).
Devices for which there are no NIST calibration standards are measured against in-house performance standards using accepted test
procedures.
WARNING
Unauthorized user modifications or application beyond the published specifications may result in electrical shock hazards or
improper operation. Fluke Biomedical will not be responsible for any injuries sustained due to unauthorized equipment
modifications.
Restrictions and Liabilities
Information in this document is subject to change and does not represent a commitment by Fluke Biomedical. Changes made
to the information in this document will be incorporated in new editions of the publication. No responsibility is assumed by
Fluke Biomedical for the use or reliability of software or equipment that is not supplied by Fluke Biomedical, or by its
affiliated dealers.
Manufacturing Location
The CuffLink NIBP Analyzer is manufactured in Everett, Washington by Fluke Biomedical, 6920 Seaway Blvd., Everett,
WA, U.S.A.