Grass Valley GV STRATUS Installation v.3.1 - Manual (Page 243)

NOTE: This procedure restores the server (both C: and D: partitions) to its factory default
condition. Passwords and other site-specific configurations are reset to factory defaults.
1. Make sure that media access is stopped and that the system on which you are working is not
being used.
2. Connect all motherboard NICs to LAN connections.
3. If the server has a 10 Gig connection, make sure it is connected to the 10 Gig connection on the
Ethernet switch.
If not connected to a switch, 10 Gig network adapter detection and ordering are unpredictable
on the restored image.
4. If you have not already done so, connect keyboard, monitor, and mouse.
5. Do the following:
a) Insert the Recovery CD.
b) Restart the machine.
If there is a problem restarting, hold the standby button down for five seconds to force a hard
shutdown. Then press the standby button again to startup.
The system boots from the Recovery CD.
The Acronis program loads.
6. At the startup screen, select True Image Server OEM (Full Version) .
The Acronis main window appears.
7. In the Acronis main window, click Recovery .
The Restore Data Wizard opens.
8. On the Welcome page, click Next .
9. On the Backup Archive Selection page, in the tree view expand the node for the E: partition and
select the image file, then click Next .
10. On the Restoration Type Selection page, select Restore disks or partitions and then click Next .
11. On the Partition or Disk to Restore page, select (C:) and then click Next .
12. On the Restored Partition Location page, select (C:) and then click Next .
13. On the Restored Partition Type page, leave the selection at Active and then click Next .
14. On the Restored Partition Size page, leave settings at their defaults. The size reported in the upper
pane is the size detected of the actual C: partition. This should be the same as that reported in
the Partition size field in the middle of the page. Free space before and Free space after should
both be reported at 0 bytes. Click
Next .
15. On the Next Selection page, select Yes, I want to restore another partition or hard disk drive and
then click Next .
16. On the Partition or Disk to Restore page, select (D:) and then click Next .
17. On the Restored Partition Location page, select (D:) and then click Next .
opens.
18. On the Restored Partition Type page, leave the selection at Primary and then click Next .
2013 12 19 GV STRATUS Installation and Service Manual 243
Administering and maintaining the GV STRATUS system