Grass Valley GV STRATUS Installation v.3.1 - Manual (Page 334)

• The server on which you are installing software has its credentials set in SiteConfig to allow
access.
1. Verify the SiteConfig roles currently assigned to the server. If the roles are not correct for your
system design, add or remove roles accordingly. Roles are as follows:
• GV STRATUS Event Viewer
• GV STRATUS Proxy K2 SAN Server
• StorNext File System Client
2. Add the server to a deployment group, such as the GV STRATUS deployment group.
3. Add the following files to the deployment group:
• GrassValley_K2system_x.x.x.cab , which contains the following cab files that apply to this
device:
• GrassValleyK2Server_x64_x.x.x.cab
• SNFS_x64_x.x.x.cab
• GrassValley_STRATUS_GVEventViewer_x.x.x.cab
• GrassValley_STRATUS_HttpProxyServer_x.x.x.cab
The GrassValley_CoreServer_x.x.x.cab is not deployed.
Refer to release notes for version numbers.
4. Do the SiteConfig Check Software operation on the server.
NOTE: If an "Unable to copy ... to target" error appears for a device that has Grass Valley
Embedded Security, put Embedded Security in Update mode.
5. Verify that deployment tasks are set to Install for the files listed above.
If a WFRegMon install task appears, install it as well. It is required to support Grass Valley
software installers. There is no uninstall task.
6. Deploy software to the server.
7. Restart as prompted.
Next, use K2Config and set up the Proxy server on the K2 SAN.
Related Topics
Adding a software role to a device on page 218
Configuring deployment groups on page 376
Check all currently installed software on GV STRATUS devices on page 69
Add software package to deployment group for GV STRATUS devices on page 388
GV STRATUS devices and their roles, cab files, services, and licenses on page 185
334 GV STRATUS Installation and Service Manual 2013 12 19
Complete system set up and configuration