Grass Valley GV STRATUS Installation v.3.1 - Manual (Page 459)

which means it manages all your XRE Nodes. Configure XRE Node settings only on your other
EDIUS XRE Servers. Then all your servers are XRE Nodes and available to render EDIUS projects.
1. Configure XRE Management Server settings as follows:
a) From the Windows desktop, click Start | All Programs | Grass Valley | XREManagementServer .
b) From the Windows desktop system tray, right-click XREManagementServer and select Settings .
If system tray icons are not present, verify that EDIUS licensing is complete. Missing icons
can indicate the software is not licensed.
The XREMangementServer setting dialog box opens.
c) Click Select and make settings as follows.
Table 13: XRE Management Server settings
Value Setting
The default location for your EDIUS XS projects, as specified in
GV STRATUS Control Panel EDIUS Settings. This is a shared
folder on K2 storage, for example
\\k2-san-fsm\EDIUS_Projects . Make sure this path uses the
standard convention of UNC path with hostname (not drive letter
or IP address) for EDIUS access to K2 storage.
NOTE: You must click Select , browse through the network to
the K2 storage device (FSM), and select the folder in order to
enter the path in the standard convention.
Project folder
The port assigned for communication with the EDIUS XRE Server,
as specified in GV STRATUS Control Panel EDIUS Settings. The
default port number is 1223. Port
As desired, the number of days to retain information about EDIUS
XRE jobs. For example, enter
30 to specify 30 days.
Days to keep jobs in
history
d) Click OK to save settings and close.
2013 12 19 GV STRATUS Installation and Service Manual 459
Complete system set up and configuration