Yaskawa R1000 Series Power Regenerative Unit - Manual (Page 219)

D.4 CSA Standards Compliance
YASKAWA ELECTRIC TOEP C710656 08B YASKAWA Power Regenerative Unit - R1000 Instruction Manual 219
St
and
ar
ds Co
mpl
ia
nce
D
D.4 CSA Standards Compliance
◆ Conditions of Acceptability
Refer to Conditions of Acceptability on page 207 .
◆ Installing Standard Configuration Devices
Refer to Standard Configuration Devices on page 204 for details on the standard configuration devices.
◆ Main Circuit Terminal Wiring
Yaskawa recommends using closed-loop crimp terminals on all regenerative unit models. To maintain UL/cUL or CSA
approval, UL Listed or CSA Certified closed-loop crimp terminals are specifically required when wiring the regenerative
unit main circuit terminals on models 2A0035 to 2A0105, 4A0035 to 4A0300. Use only the tools recommended by the
terminal manufacturer for crimping. Refer to
Closed-Loop Crimp Terminal Recommendations on page 212 for
closed-loop crimp terminal recommendations. The wire gauges listed in the following tables are Yaskawa
recommendations. Refer to local codes for proper wire gauge selections.
◆ Low Voltage Wiring for Control Circuit Terminals
The external power supply shall be a CSA certified or cUL Listed Class 2 power source only or equivalent. Refer to
Table D.5 for details.
◆ CSA for Industrial Control Equipment
The R1000 is CSA certified as Industrial Control Equipment Class 3211.
Specifically, the R1000 is certified to: CAN/CSA C22.2 No.0-10 and CAN/CSA C22.2 No.14-13.
Figure D.5
Figure D.5 CSA Mark
◆ CSA for Elevator Equipment
The R1000 is tested and complies with CSA B44.1-11/ASME A17.5-2011 standard.
This standard is used by CSA to evaluate the R1000 to Class 2411 (Elevator Equipment).
Figure D.6
Figure D.6 CSA B44.1-11/ASME A17.5-2011 Mark
YAI
CSA B44.1 /
ASME A17.5
YAI
TOEP_C710656_08B_1_0.book 219 ページ ２０１５年２月５日 木曜日 午前１０時７分