Yaskawa R1000 Series Power Regenerative Unit - Manual (Page 86)

86 YASKAWA ELECTRIC TOEP C710656 08B YASKAWA Power Regenerative Unit - R1000 Instruction Manual
5.1 Section Safety
5.1 Section Safety
W ARNING
Electrical Shock Hazard
If a fuse is open or ground fault circuit interrupter GFCI is tripped, check the wiring and the selection of the
peripheral devices.
Contact your supplier if the cause cannot be identified. Failure to comply may result in electrical shock by indirect or
direct contact. The regenerative unit can cause a residual current with a DC component in the protective earthing
conductor.
After blowing a fuse or ground fault circuit interrupter GFCI is tripped, do not attempt to restart the unit or
operate peripheral devices until five minutes pass and CHARGE lamp is OFF.
Failure to comply could result in death, serious injury, and damage to the unit.
Do not connect or disconnect wiring while the power is on.
Failure to comply could result in death or serious injury.
Before servicing, disconnect all power to the equipment. The internal capacitor remains charged even after the power
supply is turned off. The charge indicator LED will extinguish when the DC bus voltage is below 50 Vdc. To prevent
electric shock, wait for at least the time specified on the warning label; after all indicators are OFF, measure for unsafe
voltages to confirm the unit is safe prior to servicing.
Do not operate equipment with covers removed.
Failure to comply could result in death or serious injury.
The diagrams in this section may illustrate units without covers or safety shields to display details. Be sure to reinstall
covers or shields before operating the unit and run the unit according to the instructions described in this manual.
Do not touch terminals before the capacitors have fully discharged.
Failure to comply could result in death or serious injury.
Before servicing, disconnect all power to the equipment. The internal capacitor remains charged even after the power
supply is turned off. The charge indicator LED will extinguish when the DC bus voltage is below 50 Vdc. To prevent
electric shock, wait for at least the time specified on the warning label; after all indicators are OFF, measure for unsafe
voltages to confirm the unit is safe prior to servicing.
Do not allow unqualified personnel to perform work on the unit.
Failure to comply could result in death or serious injury.
Installation, maintenance, inspection and servicing must be performed only by authorized personnel familiar with
installation, adjustment and maintenance this equipment.
Do not perform work on the unit while wearing loose clothing, jewelry, or without eye protection.
Failure to comply could result in death or serious injury.
Remove all metal objects such as watches and rings, secure loose clothing and wear eye protection before beginning
work on the unit.
Do not remove covers or touch circuit boards while the power is on.
Failure to comply could result in death or serious injury.
TOEP_C710656_08B_1_0.book 86 ページ ２０１５年２月５日 木曜日 午前１０時７分