Other adahrs calibrations -12 – Dynon Avionics SkyView System Installation Guide User Manual
Page 104
SV-ADAHRS-200/201 Installation and Configuration
5-12
SkyView System Installation Guide - Revision S
Synthetic Vision License
SkyView displays can be purchased with or without a license pre-installed that allows Synthetic
Vision to be shown. In order to display Synthetic Vision, each SkyView display must be
individually licensed to display it.
To check whether a display is licensed to display Synthetic Vision, go to SETUP MENU > LOCAL
DISPLAY SETUP > LICENSE, and look at the status of the SYNTHETIC VISION line. If it is licensed,
Synthetic Vision will be displayed as long as SkyView has a valid GPS position signal and has the
appropriate high resolution terrain database installed for the region of the world that you are
flying in. See the Terrain Data section of this manual for information about obtaining and
loading terrain data to SkyView (high resolution terrain data is available for free from Dynon
Avionics.)
To enable Synthetic Vision on displays that do not have it pre-installed, a license that allows a
single display to display Synthetic Vision can be purchased in one of two ways:
1. Call Dynon Avionics directly at 425-402-0433 with your SkyView display model (SV-D100
or SV-D700) and serial number (as displayed on the case sticker, or in SETUP MENU >
LOCAL DISPLAY SETUP > DISPLAY HARDWARE INFORMATION). A License Code can be
purchased for the particular display you wish to enable Synthetic Vision on. This six
character License Code is then entered in SETUP MENU > LOCAL DISPLAY SETUP >
LICENSE > LICENSE CODE.
2. A SkyView Synthetic Vision Certificate may be purchased from Dynon Avionics or any
authorized Dynon Avionics retailer. This certificate can be redeemed for a license code
that can be entered in SETUP MENU > LOCAL DISPLAY SETUP > LICENSE > LICENSE CODE
to enable Synthetic Vision. To redeem a certificate simply follow the instructions on the
certificate itself. Similar to the above, you will need to redeem your certificate by
visitin
with your SkyView display model and serial
number ready. Alternatively, you can call Dynon Avionics directly at 425-402-0433 to
redeem a certificate.
Other ADAHRS Calibrations
AOA/Pitot Probe Calibration
If the Dynon AOA/Pitot probe is installed, familiarize yourself with the AOA calibration
procedure before flight by reading through the instructions in the AOA Calibration Wizard
(SETUP MENU > HARDWARE CALIBRATION > ADAHRS CALIBRATION > AOA CALIBRATION).
Once you are flying straight and level at a safe altitude for stalls, go into the AOA Calibration
Wizard (IN FLIGHT SETUP MENU > AOA CALIBRATION…) and follow the onscreen instructions to
calibrate angle of attack while in flight.
Altitude Adjust
There is a single point altitude adjustment, located in SETUP MENU > HARDWARE CALIBRATION
> ADAHRS CALIBRATION > ALTITUDE ADJUST that adjusts SkyView’s barometric altimeter. This