Dynon Avionics SkyView System Installation Guide - Manual (Page 82)

SV-D700 / SV-D1000 / SV-D1000T Installation and Configuration
4-20 SkyView System Installation Guide - Revision S
MGL Avionics V6/V10 COM Radio
The V6 and V10 do not transmit status or frequencies via serial port, so V6/V10 information
cannot be displayed on the top bar of the SkyView display(s). SkyView can send COM radio
frequencies to the V6/V10 (TUNE COM).

Connect V6/V10 RS232 DATA1 - IN (DSUB 25 Pin 3) to a SkyView serial TX. If you have more
than one SkyView display, make the same connection to all SkyView displays.

Ensure there is a shared ground between the SkyView display and the V6/V10. If you have
more than one SkyView display, make the same connection to all SkyView displays.

On the V6/V10, configure the serial port appropriately (per MGL Avionics’ documentation).
On SkyView

SETUP MENU > SYSTEM SETUP > SERIAL PORT SETUP > SERIAL PORT x SETUP > SERIAL IN
DEVICE > MGL V6/V10. This will automatically set the SERIAL IN FUNCTION, SERIAL IN/OUT
BAUD RATE, and SERIAL OUT DEVICE. (Although there is no V6/V10 serial TX to SkyView
serial RX connection, SERIAL IN DEVICE must be configured as described.)

SETUP MENU > SYSTEM SETUP > PRIMARY COM > MGL V6/V10 (PORT x)
and
SETUP MENU > SYSTEM SETUP > DISPLAY COM IN TOP BAR > NO
f.u.n.k.e. Avionics ATR833 8.33 kHz-capable COM Radio
Garmin GTR 200
Garmin GTR 225 and Garmin GNC 255 8.33 kHz-capable COM Radio
Trig Avionics TY91 and TY92 8.33 kHz-capable COM Radio
1
SkyView can display COM radio information from the ATR833, GTR 200, GTR 225, GNC 255,
TY91, and TY92 on the SkyView top bar and send COM frequencies to them (TUNE COM).
Note that SkyView does not send database information for the GTR 200 to enable the GTR
200’s “Nearest or Flight Plan Airports” feature.

Connect the radio’s serial RX to a SkyView serial TX. If you have more than one SkyView
display, make the same connection to all SkyView displays.

Connect the radio’s serial TX to one of the SkyView serial RX pins on each display. If you
have more than one SkyView display, make the same connection to all SkyView displays.

Ensure there is a shared ground between the SkyView display, and the radio. If you have
more than one SkyView display, make the same connection to all SkyView displays.

Configure the serial port on the radio appropriately.

Configure the serial port: SETUP MENU > SYSTEM SETUP > SERIAL PORT SETUP > SERIAL
PORT x SETUP > SERIAL IN DEVICE >
FUNKE ATR833 or
GARMIN GTR 200 or
1
Full TY91/92 8.33 kHz support depends on a future software update from Trig.