Dynon Avionics SkyView System Installation Guide - Manual (Page 48)

Basic SkyView Display Operation
3-4 SkyView System Installation Guide - Revision S
A button has a function if there is a label above it. If there is no label, there is no function. The
figure below shows an example button label.
Figure 12 – Example Button Label
When you press a button, its label is highlighted. When you let go, that button’s action is
invoked.
Button labels are called out in all capital letters such as BACK, EXIT, FINISH, and
CLEAR. This guide directs users to press a button by using its label. For example,
when this guide asks you to press FINISH, it is asking you to press the button with
the FINISH label above it.
Joystick and Button Operation Example
Some parameters may need to be adjusted using a joystick. When setting values with the
joystick, each character (symbol, letter or digit) must be selected and adjusted successively.
Figure 13 – Adjusting Successive Characters
In this example, the first time you turn the joystick, you toggle between the “-“ and “+”
symbols. To change the succeeding characters, you must move the cursor joystick to the right.
In this example, you first adjust the “-” or “+” character, move the joystick right, then adjust the
one hundreds digit, and so forth. Once you have adjusted the value appropriately, press
ACCEPT or move the joystick to the right again.
At times, the next item in the menu path in this guide may be a joystick selection OR a button
push—the correct choice will be apparent.