Dynon Avionics SkyView System Installation Guide - Manual (Page 340)

Appendix A: Maintenance and Troubleshooting
20-2 SkyView System Installation Guide - Revision S
following directions. Note that there are 3 different procedures for returning SkyView SV-
D1000/SV-D700 displays to service, depending on how the display is returned:
SV-D1000 / SV-D700 Display Scenario 1: When the documentation furnished with the
repaired display indicates that is being returned to you with the exact same
settings/configuration as it was sent to Dynon with
1. In this case, the display contains EXACTLY the same configuration as it did when you
sent it in. If your system was working properly before the display failed and was sent in
for repair:
a. Reinstall the display, reconnecting all harnesses and connections as originally
installed.
2. Power up the entire SkyView System (all displays, modules, servos, etc.)
3. If this is the only display installed:
a. Reconfigure SkyView Network under SETUP MENU > SYSTEM SETUP > NETWORK
SETUP > CONFIGURE…
b. Confirm all SkyView Network components are found, including ALL displays that
are in the aircraft.
4. If there is another display installed in the aircraft:
a. Using a display that never left the aircraft (and is presumably configured and
working correctly):
i. Reconfigure SkyView Network under SETUP MENU > SYSTEM SETUP >
NETWORK SETUP > CONFIGURE…
ii. Confirm all SkyView Network components are found.
5. Confirm that all settings, behavior, and configuration are normal.
6. If your SkyView system is not working normally, contact Dynon Avionics Technical
Support (contact information at the beginning of this manual) for further assistance.
SV-D1000 / SV-D700 Display Scenario 2: When repaired display is the ONLY display in
the aircraft, and the documentation furnished with the repaired unit indicates that
the display was shipped “like new”
1. Reinstall the display, reconnecting all harnesses and connections as originally installed.
2. Power up the entire SkyView System (all displays, modules, servos, etc.).
3. If you have a settings backup on a USB flash drive:
a. Load settings backup via SETUP MENU > SYSTEM SOFTWARE > LOAD FILES.
b. Confirm that the tail number under SYSTEM SETUP > AIRCRAFT INFORMATION is
now set to the actual aircraft tail number, not DYNON.
c. Reconfigure SkyView Network under SETUP MENU > SYSTEM SETUP > NETWORK
SETUP > CONFIGURE…
d. Confirm all SkyView Network components are found.
e. Confirm all settings, calibrations, and behaviors are as expected. Dynon
recommends using the Installation Guide to walk through each set up section to
confirm proper system operation.
4. If you do not have a settings backup, use the SkyView Installation Guide to perform ALL
setup and configuration steps as if the entire system is being installed for the first time.