Dynon Avionics SkyView System Installation Guide User Manual
Page 71
SV-D700 / SV-D1000 / SV-D1000T Installation and Configuration
SkyView System Installation Guide – Revision S
4-9
further setup tasks can be performed from any display.
When you first power up your SkyView display, it will look similar to the screen below. This is
normal – you have not yet performed a SkyView Network Configuration for the SkyView
display(s) to recognize your ADAHRS, EMS, and other SkyView Network modules.
Figure 21 – New display, SkyView Network not yet configured
Use the following procedure to configure a SkyView network:
1.
Navigate to the CONFIGURE… Page (SETUP MENU > SYSTEM SETUP > NETWORK SETUP
> CONFIGURE…).
2.
Press DETECT. A successful network configuration yields the screen in Figure 22.
3.
Press FINISH to close the screen and return to the Network Setup Menu.