Dynon Avionics SkyView System Installation Guide - Manual (Page 362)

Appendix C: Wiring and Electrical Connections
22-4 SkyView System Installation Guide - Revision S
USB Cable (from D37 connector)
The USB cable used in the SV-HARNESS-D37 is a unique part made to Dynon’s specifications
for this application and is not sold separately. Attempting to terminate a typical USB cable to a
DSUB connector causes the USB device to perform marginally (in our experience). For that
reason, we recommend that a homemade version of the Dynon SV-HARNESS-D37 to not
include a USB cable. Instead, purchase USB extension cables to plug into the two USB ports on
the back of the SkyView display.
SV-BAT-320 Connection
To connect a homemade harness to an SV-BAT-320, the following specifications must be
followed closely for the SV-BAT-320 to charge and work correctly:
Connector:
Molex Micro-Fit P/N 43640-0301 (Digi-Key P/N WM1856-ND)
Pins: Molex Micro-Fit P/N 43031-0007 (Digi-Key P/N WM1841-ND)
Wire: 22 AWG Tefzel, NO MORE THAN 24” LONG; red w/yellow: M22759/16-22-24;
black: M22759/16-22-0
Function
SkyView D37
Connector Pin
Molex
Connector Pin
Power 2 3
Ground 23 1
Table 73 – SV-BAT-320 Wiring
OAT Connection
For customers that are converting from other Dynon products, you can use your installed OAT
with the addition of the connector below. Both 100433-000 and 100433-001 are compatible.
The OAT wiring can be extended as required. If you have 100433-001, ignore the red wire and
connect the yellow and blue wires to the connector below. The OAT is non-polarized; either
wire can connect to either pin.
Connector: Molex Micro-Fit P/N 43645-0200 (Digi-Key P/N WM1845-ND)
Pins: Molex Micro-Fit P/N 43030-0007 (Digi-Key P/N WM1837-ND)
Wire: 22 AWG Tefzel
SkyView Equipment Electrical Connections
A SkyView display (SV-D700 and SV-D1000) has six connectors on the back of the unit as
illustrated in Figure 121:

One male D37 for connection to the SkyView Display Harness (SV-HARNESS-D37)

Two male D9 SkyView network connectors

Two Standard 4-pin USB 2.0 jacks for use with USB Series A plugs. Note that there is also a
USB port on the SV-HARNESS-D37 for convenience.