Dynon Avionics SkyView System Installation Guide - Manual (Page 95)

SV-ADAHRS-200/201 Installation and Configuration
SkyView System Installation Guide – Revision S 5-3
An SV-ADAHRS-200/201 should be mounted within one degree of parallel to all three aircraft
axes, with the pneumatic fittings facing toward the front of the aircraft.
To ensure that the Slip/Skid Ball will be displayed as centered during flight, the SV-
ADAHRS-200/201 must be installed to 0° (absolute level). There is no adjustment in
SkyView to electronically level the SV-ADAHRS-200/201. If, after installation, the
Slip/Skid Ball is not centered, you will need to shim the SV-ADAHRS-200/201 to be
0° (absolute level). During installation, it may be necessary to use an electronic
level as a “spirit” or “bubble” level may not be able to display an accurate enough
degree of level.
The module’s mounting tabs must be on the bottom. The label must be on the top. Figure 25
shows the correct orientation of the ADAHRS as it would appear if you were above the aircraft,
looking down at it. The module will not operate properly if it is rotated or inverted in any other
orientation.
Dynon does not provide mounting hardware with SV-ADAHRS-200/201. The mounting tabs on
each side of the module have holes sized for #10 fasteners, but it is up to the installer to decide
how the ADAHRS will be secured to the aircraft.
We recommend that installers use button-head style non-ferrous (brass recommended)
fasteners in this location. Follow recommended torque practices when tightening the mounting
hardware. Do not rivet the SV-ADAHRS-200/201 to the aircraft as this will hinder future removal
if necessary.
Do not use a magnetic driver when installing the ADAHRS. Doing so has the
potential to affect the factory magnetic calibration.
SkyView Network Connection
Connect the ADAHRS module to the SkyView network using the hardware mentioned in the
SkyView System Construction Section or using equivalent hardware.
If you have to install a connector on the end of a network cable, insert all pins into the D9
connector. Refer to Appendix C: Wiring and Electrical Connections for details on connector pin-
outs and wire colors.
Remember to configure the network as described in the Network Setup and Status
section after connecting all modules to a display.