Dynon Avionics SkyView System Installation Guide User Manual

Page 38

Advertising

System Planning

2-16

SkyView System Installation Guide - Revision S

The Ethernet connection between SkyView displays is made in addition to the 9 pin SkyView
Network connections, and should be connected on a permanent basis like other SkyView
wiring. Dynon Avionics strongly recommends “Low Smoke Zero Halogen” Ethernet cables for
use in aircraft, but any Ethernet cable – whether it is a “crossover” or normal “straight” type
Ethernet cable - will technically work. Low Smoke Zero Halogen Ethernet cables are available
from Dynon Avionics (SV-ETHERNET-3CC). Aircraft containing more than two SkyView displays
will need an Ethernet switch with enough ports to connect all SkyView displays together.
Contact Dynon Avionics for Ethernet switch recommendations if your aircraft has more than
two displays.

There are indicator lights on the Ethernet port that are usually indicative of data
transfer on traditional Ethernet devices. In SkyView, they are used instead for
display troubleshooting purposes. See the Maintenance and Troubleshooting
chapter for more information about what these lights indicate.

Available Cables and Harnesses

The following table contains Dynon part numbers and descriptions for the components that will
typically be used to test and build a SkyView system. Note: network cables with the “CP” suffix
include the second connector—it just is not installed on the cable to facilitate easy routing
through tight areas of an aircraft.

Dynon Part Number

Description

SV-HARNESS-D37

SkyView Display Harness with Aircraft-Grade Tefzel

Wiring

SV-ETHERNET-3CC

SkyView Ethernet Cable - Low Smoke Zero Halogen (3 foot)

SV-NET-1.5CC