Dynon Avionics SkyView System Installation Guide - Manual (Page 53)

Basic SkyView Display Operation
SkyView System Installation Guide – Revision S 3-9

XPNDR – This menu allows users to control a Dynon SV-XPNDR-261/262 transponder, if
equipped.

MAP – This menu allows users to control the Navigation Mapping Software features of SkyView.
Note that this button only appears when the SV-MAP-270 software has been purchased and
licensed, or when it is in its 30 hour free introductory trial period.

SCREEN – This menu allows users to set the backlight level, toggle the state of the three
information pages (PFD, ENGINE, and MAP), and change the layout of the screen.
Message Notification Area
Important alerts are relayed to users via the Message Notification Area. A flashing “Message”,
“Caution”, or “Warning” label above the rightmost button indicates the presence of a message
or alert. Press the rightmost button to bring up the Message Window to read the alert or
message. More information regarding messaging and alerting behavior is in the SkyView Pilot’s
User Guide.
In Flight Setup Menu
This menu contains links that may be useful during flight:

ADAHRS SOURCE SELECTION…

FLIGHT ANGLE PITCH ADJUST…

AOA CALIBRATION…

AUTOPILOT SETUP…

ENTER FULL SCREEN SETUP MENU…
Note that this menu occupies only half of the screen and that all of the links in the In Flight
Setup Menu are accessible via the Setup Menu.
Setup Menu
This menu contains links to system configuration options:

SYSTEM SOFTWARE

SYSTEM SETUP

LOCAL DISPLAY SETUP

PFD SETUP

EMS SETUP

MAP SETUP

AUTOPILOT SETUP

TRANSPONDER SETUP (DYNON SV-XPNDR-261/262)

TRAFFIC SETUP

VP-X SETUP

ADS-B STATUS

COM RADIO SETUP

HARDWARE CALIBRATION