Dynon Avionics SkyView System Installation Guide - Manual (Page 263)

SV-ADSB-470 Installation, Configuration, and Testing
SkyView System Installation Guide – Revision S 14-3
Figure 91 – SV-ADSB-470 Dimensions/Connections (front view)
Installation Instructions
The SV-ADSB-470 is designed to be mounted in any convenient location in the cockpit, the
cabin, or an avionics bay.
The following installation procedure should be followed, remembering to allow adequate space
for installation of cables and connectors.

Select a position in the aircraft that is not too close to any high external heat source.
(The SV-ADSB-470 is not a significant heat source itself and does not need to be kept
away from other devices for this reason).

Avoid sharp bends and placing the cables too near to the aircraft control cables.

Secure the SV-ADSB-470 to the aircraft using its four (4) mounting holes. The device
should be mounted to a flat surface. The mounting tabs on each side of the module
have holes sized for #8-32 fasteners, but it is up to the installer to decide how the
module will be secured to the aircraft.
Additional items you will require, but which are not in the SV-ADSB-470 package, include:

Antenna and fixing hardware. Antenna selection suggestions are available in the
following section.

Cables and female BNC connector. You need to supply and fabricate all required cables.
Guidance on cable types is given below.

Mounting hardware: To secure the SV-ADSB-470 to the aircraft.
Electrical Installation
Because the SV-ADSB-470 can be mounted in a variety of locations, the harness length
requirements will vary from airplane to airplane. Therefore, Dynon Avionics does not supply
pre-manufactured harnesses for the SV-ADSB-470. Instead, your SV-ADSB-470 shipped with the
required D9 connector and pins to generate a suitable harness. Refer to the sections below for
detailed wiring information.
If you do not own a D-sub machined-pin crimping tool, they can be obtained for under $50 from
many retailers. See http:// wiki.dynonavionics.com/Tools_not_supplied_by_Dynon for known