Dynon Avionics SkyView System Installation Guide - Manual (Page 5)

SkyView System Installation Guide – Revision S v
Revision Revision Date Description
Updated the guide to reflect autopilot functionality, calibration, and testing information. The
most notable changes are to the Autopilot Servo Installation, Configuration, and Calibration
section.
Expanded the Input Function Section under the Serial Port Configuration Section in the SV-D700
/ SV-D1000 Installation and Configuration Chapter.
Added an important note on page 5-10 regarding the necessity of configuring airspeed
limitations for autopilot servo calibration.
Specified that the SV-EMS-220 warning light pin (D37 pin 29) should not be connected in Table
15.
The SV-GPS-250 should now be configured as INPUT FUNCTION = POS 1.
Clarified servo installation instructions regarding the connection point on the servo arm with
the linkage hardware on page 9-6.
Updated the AP Disengage/CWS Button Section on page 9-10 to say that the button is required
instead of just highly recommended.
D June 2010
Document number changed to 101320-003.
Added GPS Fix Status information.
Added Fuel Flow pulses/gallon documentation.
Clarified EMS GP input compatibility.
Added information about obstacles and runways to synthetic vision section.
Added information about new autopilot pitch axis settings.
Added information about optional External Alarm Light connection.
Added information about fuel computer settings.
Updated autopilot test procedures with additional warnings and precautions.
E October 2010
Reiterated the importance of proper ADAHRS orientation and other installation requirements.
Added note about servo self-lubrication.
Clarified lack of specific boom-mount AOA/Pitot installation instructions.
Added information about serial device and display connection requirements.
Added firmware upgrade information for servos being used from D10/D100 with older
firmware.
Clarified GPS serial connection wire functions and colors.
Added SV-XPNDR-261/262 installation instructions and specifications.
Added SV-ARINC-429 installation instructions and specifications.
Added new requirement to connect TX and RX lines from serial devices to ALL displays in
parallel.
Added information about Autopilot servos not needing lubrication.
Clarified lack of boom mount AOA/Pitot mount availability.
F December 2010
Clarified that cable-side transponder TNC connector is not provided by Dynon.
Added SV-BAT-320 connection information for customers making their own harnesses.
Added OAT connection information for customers making their own harnesses.
Removed 30K resistor requirement for Rotax trigger coil RPM pickup.
Clarified SV-GPS-250 connections when multiple displays and/or SV-GPS-250 modules are
involved.