Dynon Avionics SkyView System Installation Guide - Manual (Page 310)

SV-COM-X83 Installation, Configuration, and Testing
17-8 SkyView System Installation Guide - Revision S
Electrical Connections
Harness Construction
Because the SV-COM-X83 (SV-COM-PANEL connected to SV-COM-T8) can be mounted in a
variety of locations, the harness length requirements will vary from airplane to airplane. Thus,
Dynon Avionics does not supply pre-manufactured harnesses for the SV-COM-X83. Instead,
your SV-COM-X83 includes connectors and pins to generate a wide variety of harness
configurations. Refer to the sections below for detailed wiring information.
Additional harness construction and wiring information can be found in Appendix C: Wiring and
Electrical Connections.
The SV-COM-PANEL has two (electrically identical) D9 male connectors for connection to
SkyView Network and one D15 male connector for connection with the SV-COM-425 and an
optional Frequency Flip/Flop pushbutton input.
The SV-COM-T8 has one D25 male connector for connection to the SV-COM-PANEL, power,
audio, and Push to Talk (PTT). A single TNC coaxial connector attaches to the antenna.
SV-COM-PANEL – Pinout (Male D15)
Pin Function Notes
1 POWER IN 10-30V DC @ 5A
2 GROUND IN Connect to Ground Bus
3 Ground Out
Optional - For Grounding Pin 7 (Flip/Flop
Switch). Switch may also be grounded
locally.
4 Panel RX / 425 TX Connect to SV-COM-T8 Pin 6
5 Panel TX / 425 RX Connect to SV-COM-T8 Pin 5
6 Enable Connect to SV-COM-T8 Pin 13
7
External Flip/Flop
(optional)
Push Button Normally Open to Ground
(Pin 3 or local ground)
8 No Connection (Pin not used)
9 No Connection (Pin not used)
10 No Connection (Pin not used)
11 No Connection (Pin not used)
12 No Connection (Pin not used)
13 No Connection (Pin not used)
14 No Connection (Pin not used)
15 No Connection (Pin not used)
Table 61 – SV-COM-PANEL male D15 Pinout