Dynon Avionics SkyView System Installation Guide User Manual
Page 197
SkyView System Installation Guide - Revision S
10-1
10.
Autopilot Servo Installation, Configuration, and Calibration
This chapter contains generic mechanical and electrical installation guidelines for the Dynon
servos mentioned in Table 46. Plane-specific kits purchased from Dynon contain detailed
drawings and diagrams which are intended to be used in conjunction with this guide as a
complete set of installation instructions. A complete list of aircraft mounting kits is available on
the current Price List/Order Form at
rawings and diagrams
are also available at http://docs.dynonavionics.com.
Figure 60 is a high-level overview of a suggested servo installation, configuration, and
calibration procedure.
Install SkyView
network cabling
Install servo
power wiring with
fuse(s) or
breaker(s)
Calibrate and test
servos
*Assumes SV-D700 or SV-D1000 is properly installed and working.
Research Dynon
resources for
autopilot
application
Choose servo
location(s)
Use premade
mounting
bracket(s)?
Yes
No
Fabricate
mounting
bracket(s)
Install mounting
bracket(s) with
Range of Motion
Limiting Bracket
Install servo(s)
Install linkage
hardware
Configure
SkyView Network*
Install
disengage/CWS
button and wiring
Configure pitch
and roll axes and
disengage/CWS
options
Flight test and fine
tune autopilot
Figure 60 – Suggested Servo Installation, Configuration, and Calibration Procedure
Of note to customers that are either upgrading their D10A/D100 series products to
SkyView: Autopilot servos shipped prior to December 1st, 2009, require that they
be upgraded to Version 5.2 Software or higher before they can connect to a
SkyView Network. Autopilot servos shipped prior to this date MUST be upgraded to
the latest version using a D10/D100 Series product BEFORE they are connected to
SkyView. This will then allow the SkyView Network to communicate with the servo.