Dynon Avionics SkyView System Installation Guide - Manual (Page 6)

vi SkyView System Installation Guide - Revision S
Revision Revision Date Description
Added pinout table for Dynon Capacitance-to-Voltage Converter.
G March 2011
Added connector labels to SkyView Network Module and Display Diagrams.
Fixed orientation of SkyView connectors on diagrams.
Clarified acceptable SV-ADAHRS-200/201 orientation.
Added additional Garmin 430 and SL30 configuration information.
Fixed link to AOA information on Dynon web site.
Added LED status troubleshooting information for SkyView modules.
Added product registration information.
Updated Garmin 480 connection details.
Added warnings about modifying products and introduction of foreign debris.
Described improved loss of external power with backup battery connected behavior.
Added G meter setup information.
Added recommended Ethernet connection information for multiple display SkyView systems.
Clarified GRT hall effect amps sensor support.
Added information about reconnecting repaired SkyView Network components to a system
after repair.
Added Synthetic Vision License and Purchase Information.
Added SV-MAP-270 License and Purchase Information.
Updated information about obtaining and managing aviation / obstacle databases, including
Jeppesen data support.
H April 2011
Removed Create System Backup description.
Added description of EMS serial data.
Changed Screen Hardware to Display Hardware.
Add flight path marker and extreme pitch warning menu items.
Clarified SV-GPS-250 connectivity.
Clarified that Ethernet is designed to be connected permanently.
I September 2011
Added angle of attack menu item.
Added OAT probe adjustment setting information.
Added Vertical Power VP-X License information and interfacing information.
Clarified serial port connections for multi-display SkyView systems in Appendix E.
Added information about which modules and devices the SV-BAT-320 can provide power to in
the event of power failure.
Added EI FT-60 fuel flow sensor orientation information.
Added a note about the importance of external devices sharing ground with SkyView for proper
operation.
Added Amps shunt fuse diagram.
Added SV-XPNDR-261/262 power wire size recommendation.
Added permission to print manual.
Added information about taking screenshots for troubleshooting purposes.
Added information about re-doing ADAHRS-based calibrations if an additional ADAHRS is
installed after calibrations have been done.