Dynon Avionics SkyView System Installation Guide - Manual (Page 7)

SkyView System Installation Guide – Revision S vii
Revision Revision Date Description
Consolidated all information about ADAHRS calibrations into the ADAHRS installation chapter.
Added ADAHRS, SYSTEM, and NMEA Serial output information to Serial Data Output Appendix.
J November 2011
Added Garmin GTN connection information.
Added Garmin serial port setting for Garmin 430/530 ARINC-429 based connections.
K March 2012
Added information about equipping for IFR.
Clarified that Jeppesen data must be transferred to USB flash drive via the Jeppesen JSUM
program.
Added PocketFMS information.
Clarified Honeywell oil pressure sensor connection information (Rotax).
Added recommendation to ensure master contactor/relay is protected by a diode.
Clarified fuel flow sensor connections.
Added UMA differential pressure sensor information.
Added backup battery test to initial installation procedures.
Changed EMS wire harness tables to indicate pin 2 may not have a wire in it (all recent Dynon
harnesses).
Clarified future use of connected TSO’d GPS to transponder for ADS-B 2020 mandate
compliance.
Clarified that a broken shear screw may be indicative of a more systemic problem that needs to
be resolved.
Added serial port test to ensure that ports are configured correctly on all displays.
Better explanation of cases when fuel tank / sensor geometry prohibits display of all fuel in
tanks.
Added Kavlico Fuel, Oil, and Coolant Pressure sensor information.
Clarified external dimming input.
Added Rotax 912 special oil temp / tachometer behavior.
Added altitude alerter setup information.
Added EMS 5/12V output current limitations information.
Added 3 rd party two wire oil temperature sensor connection instructions.
Added procedure for performing pitot/static checks.
Updated map setup instructions as former setup items are not user-accessible via normal
SkyView UI.
Clarified settings changes necessary to support capacitive fuel quantity senders.
Added audio output connection instructions.
Updated CWS Broken Line Detect instructions to reflect that the feature is now available.
L July 2012
Clarified obtaining HEX CODEs for mode S operation.
Added SV-NET-HUB drawing with dimensions.
Location of pulses/gallon setting changed in setup menu.
Added dual SV-GPS-250 + dual display example connection diagram.
Clarified VP-X flaps and trim calibration procedures.
Added Dynon Capacitance to Voltage Converter current draw information for power planning.
Clarified that audio output from ALL SkyView displays must be connected to audio