Dynon Avionics SkyView System Installation Guide - Manual (Page 31)

System Planning
SkyView System Installation Guide – Revision S 2-9
dynamic magnetic fields (e.g., AC currents, non-constant DC currents, and non-stationary
ferrous material such as electric turn coordinators and control surfaces). Thus, you must avoid
mounting the module close to sources of dynamic magnetic fields, avoid wires that carry large
amounts of current, and use non-magnetic fasteners for installation (see caution below).
Dynon’s general rule of thumb is that 1 to 2 feet between the module and sources of magnetic
fields is generally good enough, but 2 or more feet is better.
Stainless steel mounting hardware is not always non-magnetic, and thus is not
recommended. The best type of mounting hardware (screws, bolts, washers, nuts)
to install the SV-ADAHRS-200/201 is brass.
If you use a magnet to test whether possible interfering materials are non-
magnetic, do not actually touch the magnet to the material you are testing, as this
contact can cause the material you are testing to become magnetized.
Move a handheld compass throughout the space surrounding your intended
location to get a rough idea of the suitability of the area. Note that this test should
be done with major aircraft systems operating (e.g., strobe lights and radios on)
because some systems can cause magnetic interference. If the compass needle
deviates significantly from magnetic North or cycles back and forth, the location is
not ideal for ADAHRS installation.
Figure 2 – ADAHRS Installation Orientation
An ADAHRS module should be mounted within one degree of parallel to all three aircraft axes,
with the pneumatic fittings facing toward the front of the aircraft. The module’s mounting tabs