Dynon Avionics SkyView System Installation Guide - Manual (Page 79)

SV-D700 / SV-D1000 / SV-D1000T Installation and Configuration
SkyView System Installation Guide – Revision S 4-17
Gray-Code Transponder Installation
To use SkyView’s altitude encoder functionality with your Gray Code transponder:

Follow the installation instructions in the Gray-Code Transponder Installation Section. If you
have more than one SkyView display, make the same connection(s) to all SkyView displays.

Configure the serial port on each display according to the instructions on page 15-7.
Reference the Serial Port Configuration Section of this guide for serial port configuration
information.
Garmin SL30 COM / NAV Radio
In addition to the NAV radio functions of the SL30, SkyView can display COM radio information
from the SL30 on the top bar of the SkyView display(s) and send COM frequencies to the SL30
(TUNE COM).

Connect SL30 serial RX pin 4 (RxD1) to a SkyView serial TX. If you have more than one
SkyView display, make the same connection to all SkyView displays.

Connect SL30 serial TX pin 5 (TxD1) to a SkyView serial RX. If you have more than one
SkyView display, make the same connection to all SkyView displays.

Ensure there is a shared ground between the SkyView display and the SL30. If you have
more than one SkyView display, make the same connection to all SkyView displays.

Configure the serial port on the SL30 appropriately. On the SL30, the Indicator Head Type
should be set to NONE.
On SkyView

SETUP MENU > SYSTEM SETUP > SERIAL PORT SETUP > SERIAL PORT x SETUP > SERIAL IN
DEVICE > GARMIN / APOLLO SL30. This will automatically set the SERIAL IN/OUT BAUD RATE
and SERIAL OUT DEVICE.

Set SERIAL IN FUNCTION TO NAV 1, 2, 3, or 4. If the SL30 is the only NAV device, select NAV
1.

Set NAVIGATION SOURCE DISPLAY NAME: (user selectable, 7 characters, suggest SL30). The
name entered here is displayed as the HSI source and the Flight Plan Source (if this device
outputs a flight plan).

If you wish the SL30 frequency and status to be displayed on the top bar:
SETUP MENU > SYSTEM SETUP > DISPLAYED COM > GARMIN / APOLLO SL30 (PORT x)
and
SETUP MENU > SYSTEM SETUP > DISPLAY COM IN TOP BAR: YES
Val Avionics NAV 2000

To work with SkyView, the NAV 2000 must have v1.10 firmware (minimum). The firmware
version is displayed during the NAV 2000 startup.

Connect NAV 2000 serial RX Pin 4 (Connector P1) to a SkyView serial TX. If you have more
than one SkyView display, make the same connection to all SkyView displays.

Connect NAV 2000 serial TX Pin 5 (Connector P1) to a SkyView serial RX. If you have more
than one SkyView display, make the same connection to all SkyView displays.