Dynon Avionics SkyView System Installation Guide - Manual (Page 273)

Accessory Installation and Configuration
SkyView System Installation Guide – Revision S 15-3
In-flight AOA Calibration
It is your responsibility to fly your plane safely while performing any configuration
or calibration in flight. The best scenario includes a second person to perform any
necessary steps on any SkyView components.
Detailed instructions on calibrating the Dynon Avionics AOA/Pitot Probe as installed on your
plane, for your plane’s particular flight characteristics, are provided on-screen on the SkyView
display. You can preview the instructions prior to a flight: SETUP MENU (push buttons 7+8
together), then HARDWARE CALIBRATION > ADAHRS CALIBRATION > AOA CALIBRATION, as
shown in Figure 93 below.
If your panel is equipped with multiple SkyView displays, the AOA Calibration
procedure can be performed from any SkyView display, including a SkyView
display that is not configured to display PFD. As shown Figure 93 below, entering
the AOA Calibration menu automatically, temporarily, reconfigures that SkyView
display for Primary Flight Display on the left half, and the AOA Calibration
Instructions on the right half. Upon exiting the AOA Calibration menu, the SkyView
display is returned to its normal configuration.
Figure 93 – AOA Calibration Explanation and Wizard