Dynon Avionics SkyView System Installation Guide - Manual (Page 11)

SkyView System Installation Guide – Revision S xi
Revision Revision Date Description
 As of v11.0, SkyView does not have “Auto-trim” capability (Page 19-3)
 Alert Data Log (Page 26-2)
Documentation improved:
 Getting Started (Pages 1-2 through 1-4)
 SkyView System Power Specifications (Table 2, Page 2-2)
 Corrected SV-XPNDR-261/262 dimensions (Page 2-3)
 Recommendation to not use stainless steel hardware for installing SV-ADAHRS-200/201,
added recommendation to use Brass hardware (Page 2-8, Page 5-3)
 Explanation of Dynon Diagnostic File (Page 3-10 and Page 3-16)
 Updated screen shots throughout SV-D700 / SV-D1000 / SV-D1000T Installation and
Configuration (Chapter 4)
 Moved configuration information for Garmin GTX 330ES to Traffic Devices section (Page 4-14)
 VAL NAV 2000 – frequency cannot be displayed on top bar (Page 4-17)
 Updated SV-ADAHRS-200/201 Magnetic Calibration Procedure (Page 5-5)

Differences between SV-EMS-220 and SV-EMS-221 (Page 7-1)
 Rotax oil pressure sensor connector charge (Page 7-41, 7-42)
 Oil temperature sensor section, updated crush washer installation instructions. (Page 7-42)
 Rotax 914 Differential Fuel Pressure Sensor UMA N1EU07D guidance improved (Page -7-44, 7-
45)

Suppress units displayed on sensor widgets (Page 7-63)
 Effect of setting ALLOW AUTO SWITCH to YES (LABEL 100P) for 430/530 (Page 12-7) and GTN-
series (12-9)
 Setup for transponders other than SV-XPNDR-261/262 with ADS-B OUT for receiving ADS-B
Traffic information with SV-ADSB-470 (Page 14-1)

Check for blockage of AOA / Pitot lines prior to installation (Page 15-10)
 SV-COM-C25 Post Installation Checks, Continued Airworthiness and Maintenance (Page 16-8,
16-9)
 Homemade Wire Harness Considerations (Page 21-2 through 21-4)
 MAP button no longer available (Page 21-11)
 Kavlico pressure sensors information (Appendix G)
S January, 2015
New products:
 SkyView firmware v12.0
New features:
 Support for Garmin GTR 200, page 4-20
 In-flight compass calibration procedure, beginning on Page 5-6
 Airplane icon in PFD Page Compass and MAP Page is now changeable, Page 5-10
 External EMS Warning Light Test, Page 7-59
 SkyView Video Adapter can now flip the image horizontally and/or vertically, page 15-10
 Autopilot Auto-trim configuration, Section 18
 History datalog, Page 25-3
Documentation improved:
 Updated weights for major and minor units, rationalized to all the same units
 Updated Power Consumption table, Page 2-2 and 2-3
 Updated Transponder settings, Page 11-16 through 11-18
 Updated AOA/Pitot Installation (section) to defer mechanical and electrical installation to the
separate Heated and Unheated AOA/Pitot Probe Installation Guide
 Updated SkyView Network troubleshooting, improved error message, page 20-9
 Updated Table 75 - SV-EMS-221 Male D37 Transducer Connector, Page 22-10 and 22-11
 Corrected Pin 18 of SV-EMS-220/221 in Table 74 (Page 22-10) and Table 75 (Page 22-11),
incorrectly stated 500 mA output; corrected to 300 mA output.
 Updated User datalog filename explanation (Page 25-3)
 Updated Kavlico Pressure Sensor P/Ns reference – Page 26-1

Updated mentions of SV-EMS-220/221 Pin 18 fuse; added that fuse is self-resetting.
Table 1 – SkyView System Installation Guide Revision History