Dynon Avionics SkyView System Installation Guide - Manual (Page 83)

SV-D700 / SV-D1000 / SV-D1000T Installation and Configuration
SkyView System Installation Guide – Revision S 4-21
GARMIN GNC 255 A/B or
GARMIN GTR 225 A/B or
TRIG TY9X 25KHz ONLY
TRIG TY9X 8.33/25KHz
This will automatically set the SERIAL IN FUNCTION, SERIAL IN/OUT BAUD RATE, and SERIAL
OUT DEVICE.
Set the radio status to be displayed on the top bar: SETUP > SYSTEM SETUP > DISPLAYED COM >
(device you chose above) (PORT x)
and
SETUP MENU > SYSTEM SETUP > DISPLAY COM IN TOP BAR: YES
Emergency Location Transmitter (ELT)
SkyView can provide a GPS data stream to ELTs that accept GPS data in NMEA format.

Wire a serial transmit (TX) line from one display to the receive (RX) line on the ELT. If you
have more than one SkyView display, make the same connection to all SkyView displays.

Ensure there is a shared ground between the SkyView display and the ELT. If you have more
than one SkyView display, make the same connection to all SkyView displays.

Configure the SkyView display serial port:
SETUP MENU > SYSTEM SETUP > SERIAL PORT SETUP > SERIAL PORT x SETUP
SERIAL IN DEVICE: (don’t care, does not affect ELT)
SERIAL IN/OUT BAUD RATE: (set to match speed of ELT; typically 4800 or 9600)
SERIAL OUT DEVICE: NMEA OUT (BASIC)
Dynon ADAHRS / EMS / SYSTEM / NMEA (GPS) Data Outputs
To output real-time data to an external serial device, such as a serial data logger or other device
that accepts NMEA or Dynon formats:

Wire a serial transmit line from one display to the receive line on the external serial device.
If you have more than one SkyView display, make the same connection to all SkyView
displays.

Ensure there is a shared ground between the SkyView display and the external serial device.
If you have more than one SkyView display, make the same connection to all SkyView
displays.

Configure the serial port on the display appropriately under SETUP MENU > SYSTEM SETUP
> SERIAL PORT SETUP, SERIAL PORT x SETUP > selecting the desired output data format.
TIS Format Traffic Output
SkyView can be configured to output TIS format traffic information for external display on other
avionics that can receive traffic in TIS format. When this option is selected, only the actual TIS
traffic from a SV-XPNDR-261/262 is included in this serial data stream. This stream does not
include ADS-B, FLARM, Zaon, or other traffic sources that may be available to SkyView.