Dynon Avionics SkyView System Installation Guide - Manual (Page 307)

SV-COM-X83 Installation, Configuration, and Testing
SkyView System Installation Guide – Revision S 17-5

Secure the SV-COM-T8 to the aircraft via the three (3) mounting holes in the plate. The unit
should be mounted to a flat surface – it is important that the tray is supported at the
dimples as well as the three mounting points.

Put the SV-COM-T8 into the secured mounting tray by hooking the connector end under the
lip on the tray.

Lock the SV-COM-T8 into the mounting tray by clipping the retaining wire over the lugs on
the opposite end.
Additional items you will require for installation of SV-COM-X83, but which are not in the SV-
COM-X83 package, include:

Nutplates for mounting SV-COM-PANEL to the panel

To secure the transponder tray to the airframe you will need least 3 flat head screws and
three self-locking nuts. If the aircraft does not have existing mounting provisions you may
need to fabricate additional brackets to support the transponder tray.

Circuit breaker or fuse for power to SV-COM-T8 and SV-COM-PANEL

Power wires to SV-COM-T8

SV-COM-T8 to SV-COM-PANEL wiring

SkyView Network cables to connect the SV-COM-PANEL to SkyView Network

COM Antenna, coaxial cable, terminated to Male TNC connector. The SV-COM-X83 is
compatible with aircraft COM antennas commonly available.